Phase: | / |
---|---|
Type: | / |
Protection: | / |
Application: | / |
Classification: | / |
Standby Time: | / |
Samples: |
---|
Customization: |
---|
Suppliers with verified business licenses
Quantity (pieces) | 1 - 10 | > 10 |
Lead time (days) | 15 | To be negotiated |
1. Introduction
DC Power Distribution Unit is suitable to indoor low voltage DC power contribution system. Mounted in a rack cabinet and connected between the -48V DC power supply and the protected equipment, it can protect the equipment from surge and instantaneous over voltage caused by the outside environment (lightning, electromagnetic radiation interference, etc.) or by the internal subsystems (switching effect, start and stop operation of inductive and capacitive loads), it is a Class C drawer type surge protector for DC power distribution with the following features.
19 inch 1U rack installation;
output 12 outputs 48V 30A;
Circuit breaker for each of the 12 outputs ,can disconnect the circuit when fault or overload happens
Easy connection for inputs and outputs wiring;
Insulation of output connectors;
2.Power System Configuration
Nominal load current IR | Inputs:Two inputs in parallel, maximum 150A for each input and 300A for two inputs in parallel, maximum 30A for 1-12 outputs |
Rated current of circuit breaker | 30A |
Remote alarming connectors | Dry contacts 1 and 3 are closed at normal operation while open at fault |
Wiring |
Input:Pressed frame crimp connectors Output:Pressed frame crimp connectors |
Side handling | Fixed type |
Large current discharge capability and low residual voltage;
Remote signal alarm connectors (dry contacts of remote signal alarm is closed at normal operation while open at fault condition).
2.1 Operating environment
Operating temperature:-40ºC~+70ºC;
Relative humidity:5%-95%;
Atmosphere pressure:70kPa~106kPa
2.2 Storage environment
Storage temperature:-40ºC~+85ºC;
Relative humidity:5%-95%;
Atmosphere pressure:70kPa~106kPa
Storage time limit:12months
2.3 Reference standards
GB4943.2001/IEC60950:1999
Safety of information technology equipment
GB/T18802.21-2004/IEC61643-21:2000 Low voltage surge protective device, part 21, SPD for telecommunication and signal networks-performance requirements and tests.
YD/T1542-2006
Technical requirements and test methods of SPDs for signal networks
Suppliers with verified business licenses